CLEANING
Storage and food processing equipment. Thoroughly rinse surfaces with fresh cold potable water. Brush, spray or circulate a 6 gm per litre of water solution (1 oz per gal) of Vestec 225 or other suitable Vestec cleaner at 49-57°C (120-135°°F). Rinse with fresh potable water. Sanitize just before use with a Vestec 225 solution using 18 gm to 1 litre (3 oz to 1 gallon) of water. Drain and rinse thoroughly
with potable water.
Small storage tanks and vats: Rinse surfaces thoroughly with cold potable water. Prepare a slurry or paste using 18 gm per 100 litres of
tank capacity (3 oz of Vestec 225 for each 100 gallons) and scrub all surfaces with a brush. Before paste dries, rinse only with sufficient
fresh potable water to remove paste. Sanitize just before use with Vestec 225 solution using 18 gm to 1 litre (3 oz to 1 gal) water. Drain and rinse thoroughly with potable water.
Walls and floors: Mop, brush or scrub with a solution of 18 gm Vestec 225 per litre of water (3 oz per gallon). Soiled Mops and maintenance equipment. Soak in a solution of 18 gm to 1 litre Vestec 225 ( 3 oz per gallon ) of water for at least 30 minutes.
Teapots, steam tables, pots, sandwich boards, food preparation tables, meat blocks, refrigerators, fish boxes, waste cans, etc. : Rinse with cold potable water. Wash with Vestec 225 solution using 18 gm per litre ( 3 oz per gallon) of water. Thoroughly rinse with clean
potable water. Air dry where necessary.
Vestec 225 may be used in final rinse waters for on hard non-porous surfaces which have previously been cleaned with a suitable cleaning agent followed by a potable water.
Use concentrations of available chlorine must not exceed 200 ppm in final rinse waters and all reasonable precautions must be taken to avoid contamination of food.
Note that no final rinse is required in dairy and milk processing plants.
Dishware, cooking utensils, processing equipment, pipelines, tanks: Wash with a suitable Vestec cleaner. Rinse with potable water. Soak, circulate or spray a Vestec 225 solution containing a minimum of 6 gm per 2 litres ( 1 ounce to every 2 gallons) of water.
REMOVING STAINS
Sprinkle dry Vestec 225 on wet porcelain, meat block, tile or concrete surface. Allow to stand 5 to 10 minutes. Brush and rinse thoroughly with potable water.
NOTE: Do not allow aluminium ware to remain in a Vestec 225 solution over two minutes. Keep dry Vestec 225 crystals from contact
with wet silver or metal. Dry crystals on wet metals may cause tarnishing.
