Perennial ZF Floor Finish

Initial Application: Strip floor using the appropriate professional floor stripper, following the label instructions. Apply 3 or more medium coats of Perennial ZF finish using a clean finish mop. Apply additional coats until desired gloss is obtained. Allow 30-40 minutes drying time between coats. Temperature, humidity and ventilation may add to drying time. Allow finish to cure for 24 hours before spray buffing or burnishing. Maintenance: Dust mop or sweep floor first. Clean floor with a mop or automatic scrubber using the recommended cleaner, following label directions. To enhance appearance, spray buff or burnish. To spray buff, use a red pad with approx. 300 rpm equipment. Ultra-high speed burnish using a natural hair pad and 1200-2000 rpm equipment. Recoat: Dust mop or sweep. Clean floor with a mop or automatic scrubber using the recommended cleaner, following label directions. Apply 1-2 uniform coats of finish using a clean mop. Allow finish to cure for 24 hours before spray buffing or burnishing. Removal: Remove using recommended floor stripper following the directions on the label. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Disposal should be in accordance with applicable regional, national and local laws and regulations.